Filter
Top Products
HP StorageWorks 2000 G2 Modular Smart Array Reference Guide 33
To install a permanent license
1. Ensure that:
• The license file is saved to a network location that SMU can access.
• You are signed into the controller enclosure that the file was generated for.
2. In the Configuration View panel, right-click the system and select Tools > Install License.
3. Click Browse to locate and select the license file.
4. Click Install License File. If installation succeeds, the System Licenses table is updated. The licensing
changes take effect immediately.
Configuring system services
Changing management interface settings
You can enable or disable management interfaces to limit the ways in which users and host-based
management applications can access the storage system. Network management interfaces operate
out-of-band and do not affect host I/O to the system. The network options are:
• Web Browser Interface (WBI). The primary interface for managing the system. You can enable use of
HTTP, of HTTPS for increased security, or both.
• Command Line Interface (CLI). An advanced user interface for managing the system. You can enable
use of Telnet, of SSH (secure shell) for increased security, or both.
• Storage Management Initiative Specification (SMIS). Used for remote management of the system
through your network.
• File Transfer Protocol (FTP). A secondary interface for installing firmware updates, downloading logs,
and installing a license.
• Simple Network Management Protocol (SNMP). Used for remote monitoring of the system through your
network.
• Service Interface. Used for technical support only.
• Service Debug. Used for technical support only.
In-band management interfaces operate through the data path and can slightly reduce I/O performance.
The in-band options are:
• In-band CAPI Capability. Used for in-band management of the system from custom, host-based
management applications written using the Configuration Application Programming Interface (CAPI).
• In-band SES Capability. Used for in-band monitoring of system status based on SCSI Enclosure Services
(SES) data.
If a service is disabled, it continues to run but cannot be accessed. To allow users to access WBI, CLI, or
FTP, see About user accounts on page 15.
To change management interface settings
1. In the Configuration View panel, right-click the system and select Configuration > Services >
Management.
2. In the Network Management Services section, enable the options that you want to use to manage the
storage system, and disable the others.
3. Click Apply. If you disabled any options, a confirmation dialog appears.
4. Click Yes to continue; otherwise, click No. If you clicked No, a processing dialog appears. When
processing is complete a success dialog appears.
5. Click OK.