T-Mobile MDA III Cell Phone User Manual


 
T-Mobile III User Manual
96
n Disable the Infrared function by tapping > Settings > Connections tab > Beam, and then
uncheck Receive all incoming beams.
n Insert your T-Mobile MDA III to your PC/Notebook by USB connection (using the USB sync cable
or cradle).
Before setting up an USB modem, you must verify that you have the two les, USBMDM and
USBModem_Dialer, on the Companion CD. Insert the Companion CD into the CD-Rom of
your PC and perform the settings as follows:
1. Tap > Programs > Wireless Modem.
2. Select the USB connection type from the drop-down list and insert the USB cable adapter.
3. Tap the Start button on the Wireless Modem screen of your T-Mobile MDA III.
4. A Found New Hardware message will pop up on your desktop PC.
5. Select the Display a list of the known drivers for this device so that I can choose a specic
driver option, and then click
Next.
6. Select Modem from the Hardware types list > and then Next.
7. Click the Have Disk button > and then
Next.
8. Select the recognized USB Modem in the Models list, and then
Next.
After the installation completed,
click Finish.
9. After the installation, a new USB modem will be found in the Modem list by tapping Start > Settings
> Control Panel > Phone and Modem Options on your PC.
10. Double click the USBModem_Dialer le on the Companion CD and set the GPRS settings (enter
the APN assigned by your ISP) in the blank text box and press Dial to start the connection.
Connect via Bluetooth
Before starting to use your T-Mobile MDA III as a Bluetooth modem, you must be sure that your PC
is a Bluetooth-enabled device. Besides that, you still need to check the following:
n A GPRS SIM card is inserted in your T-Mobile MDA III.
n Disable the ActiveSync BT port connection of your PC.
n Disable the Infrared function by tapping > Settings > Connections tab > Beam > uncheck
Receive all incoming beams.
1. Select > Programs > Wireless Modem.
2. Select the Bluetooth connection type from the drop-down list and tap the Start button.
3. Open your T-Mobile MDA III from the Bluetooth application installed on your PC.
The interface of the Bluetooth application installed on your PC will vary, depending on the
Bluetooth module embedded or attached in your PC when you purchased it. Follow the instal-
lation instructions of the connected Bluetooth device's manual.