BMC Software, Inc., Confidential and Proprietary Information
BMC44200–BMC44299 101
BMC44270I BATCH CONTROL FACILITY INITIALIZED
Explanation: BATCH CONTROL FACILITY (BCF) has initialized the
execution controller environment.
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
BMC44271I BATCH CONTROL FACILITY NOT INITIALIZED, REASON = rc
Explanation: BATCH CONTROL FACILITY (BCF) initialization could not be
performed for the reason indicated by one of the following reason codes (rc). This
message is issued only when the Joblog Messages option has been specified as
FULL.
1 BCF has been deactivated through an option.
2 BCF is not authorized to initialize at this time. An invalid CPU ID has been
specified.
3 An attempt was made to run BCF under the Utility Control Facility (UCF).
BCF will not run under UCF.
4 BCF execution was attempted in a batch message processing (BMP) region.
BCF will not operate in a BMP region.
5 BCF execution was attempted for a program that used a read-only program
specification block (PSB) when IEFRDER DD DUMMY was specified and
EXCH=MATCH was not specified. BCF does not initialize in this case.
System Action: The BCF Active option was specified as N, or the product is
executing on an unauthorized processor. BCF has done very limited processing.
User Response: Verify that BCF is authorized to execute on the processor. If you
are using a trial copy, verify that the expiration date has not passed. The job log may
contain additional messages to explain the BCF Physical Logger failure.
Your response depends upon which reason code is returned:
1 Verify that the global BCF Active option is specified as Y.
2 Contact BMC Software Product Support for assistance.
3 This message is for your information only. No action is necessary.
4 This message is for your information only. No action is necessary.
5 This message is for your information only. No action is necessary.
