BMC Software, Inc., Confidential and Proprietary Information
82 Application Enhancement Solutions Messages Manual
BMC44214I RGX ERROR, EXECUTION MUST TERMINATE, RC = rc
Explanation: The BATCH CONTROL FACILITY (BCF) Physical Logger has
detected a critical error with the REGISET. Job step termination is necessary to
prevent possible database integrity exposures. The job log may contain additional
information concerning the REGISET error. The return code in the message provides
additional information concerning the reason for termination.
4 The execution control record could not be written to the REGISET. When
the execution control record cannot be written, job step restart might be
possible without execution of the IMS Batch Backout utility. Since DBRC
is not active for execution, the job step abnormally terminates before
database updates can be done.
System Action: The job step terminates abnormally.
User Response: Obtain the error messages from the job log concerning the
REGISET error encountered. Correct the condition that caused the error. Resubmit
the job step only after the condition that caused the error is corrected.
BMC44215E CLOSE FAILED, DDNAME = ddname, RC = rc
Explanation: The BATCH CONTROL FACILITY (BCF) Physical Logger could
not close the data set associated with the ddname.
System Action: Processing continues.
User Response: Have the job log data set available if you need to contact BMC
Software Product Support for assistance.
BMC44216E type ERROR HAS OCCURRED, DDNAME = ddname
Explanation: The given data set (ddname) being written by the BATCH
CONTROL FACILITY (BCF) Physical Logger has encountered an error of the
indicated type. A possible system or physical device error has occurred. Refer to the
job log data set for any MVS messages. The following type codes are possible:
WRITE
A write error has been detected for the logging device.
SYNC An error has been detected when attempting to use the MVS SYNCDEV
macro for the logging device.
System Action: The log data set is marked in error. If dual logging is active and a
valid log data set exists, processing continues with the remaining log data set. If there
no valid output device is available for logging, the job terminates abnormally with a
U616 abend.
User Response: This is a system or device error. If you contact BMC Software
Product Support for assistance, have the job log data set available.
