BMC Software, Inc., Confidential and Proprietary Information
Abend Codes 13
U1567 See “U621 or U1567” on page 8.
U1568 The execution controller detected that the program abended during execution.
System Action: The job step has been recovered to a point ready for job step
restart. The Program Abend option (set at the AES global level) was specified as
BMC.
User Response: This abend does not indicate a problem with BATCH CONTROL
FACILITY. This abend occurred so that, as the application program abended, it could
be recognized by any automated operations products installed on the system. If you
cannot determine the reason for the abend, ensure that a SYSUDUMP and the job
log listings are available and contact BMC Software Product Support.
U1569 See “U623 or U1569” on page 9.
U1570 See “U624 or U1570” on page 9.
U1571 See “U625 or U1571” on page 9.
U1572 See “U626 or U1572” on page 9.
U1573 See “U627 or U1573” on page 10.
U1574 See “U628 or U1574” on page 10.
U1575 See “U714 or U1575” on page 10.
U1576 The BMC Software application program interface controller was not able to correctly
initialize the IMS application program interface.
System Action: Processing terminates.
User Response: Call BMC Software Product Support, and have the job log data set
available when you call.
U1577 See “U629 or U1577” on page 10.
U1578 An error occurred during APPLICATION RESTART CONTROL (AR/CTL) for
VSAM initialization or termination.
System Action: Processing terminates.
User Response: Check the messages issued during the job step for details about the
cause of the error and the action to take.
