BMC Software, Inc., Confidential and Proprietary Information
BMC44200–BMC44299 109
BMC44296I DYNAMIC LOG NOT INITIALIZED, REASON = rc
Explanation: The execution options present for the job indicated that a dynamic
log should be built and used. The dynamic log was not built because of conflicting
execution options that prohibit usage of a dynamic log or reduce its benefit.
The following reason code (rc) values provide additional information about why the
dynamic log was not built:
1 Discard logging is being used. A dynamic log is not supported when discard
logging is being used.
2 Dynamic backout is not active for the job. Either the
BKO option was not
specified, or the Tape BKO option was not specified as Y.
3 The Batch Backout utility has been invoked to back out the failed program.
Since Batch Backout is, therefore, executing, dynamic backout is not
possible.
4 Storage could not be obtained for the dynamic log.
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
BMC44297I NOTIFY OPTION IN EFFECT, REASON=reason
Explanation: The Notify DBRC option of BATCH CONTROL FACILITY
(BCF) is in effect for the indicated reason with the following results:
1 The Notify DBRC option is set to BACKOUT. If DBRC is active, the
database is registered to DBRC, and a failure occurs, the database is marked
as Backout Needed.
2 The Notify DBRC option is set to RECOVER. If DBRC is active, the
database is registered to DBRC, and a failure occurs, the database is marked
as Recovery Needed.
3 The Notify DBRC option is set to NONE. If the processing option
(PROCOPT) in the program specification block (PSB) is L or LS, DBRC is
active, the database is registered to DBRC, and a failure occurs, BCF will
not attempt any additional processing.
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
