BMC Software, Inc., Confidential and Proprietary Information
BMC48000–BMC48099 131
BMC48074I BCF COND=ONLY STEP=stepname WILL BE FLUSHED
Explanation: The BATCH CONTROL FACILITY (BCF) Automatic Batch
Backout feature successfully performed a backout for an application that abended,
and a subsequent step in the current job meets the following condition: A
COND=ONLY parameter exists on an EXEC statement, and the job step specifies the
IMS Batch Backout utility. BCF has flushed the job step instead of executing it.
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
BMC48075I BCF IMS DYNAMIC BACKOUT REQUEST RESET, REASON=rc
Explanation: During BATCH CONTROL FACILITY (BCF) initialization, BCF
reset the IMS Dynamic Backout option. This action could have been requested by
setting the Tape BKO option to Y. The following reason codes (rc) are possible:
1 During BCF initialization, BCF found that the Ignore Checkpoints option
was set to Log. Since the Ignore Checkpoints option performs batch
backout to the beginning of the job step, IMS Dynamic Backout is not used
because it only backs out to the last checkpoint call requested.
System Action: Processing continues. IMS Dynamic Backout will not occur if it is
requested by a user abend.
User Response: This message is for your information only. No action is necessary.
BMC48076I BCF DATABASE UPDATES WERE MADE IN A NONLOGGING
ENVIRONMENT
Explanation: During abnormal termination, BATCH CONTROL FACILITY
(BCF) detected that the application program updated at least one database while the
IMS logging environment was inactive. Some form of database recovery may be
required before the job step can be re-executed. Since the IMS logging environment
was inactive, BCF cannot perform batch backout for the affected job step. BCF does
not prevent the application from re-executing.
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
BMC48077I BCF JOB CANNOT BE CANCELLED, REASON=rc, TRY LATER
Explanation: During BATCH CONTROL FACILITY (BCF) processing, the
intercept routines determined that causing the job step to abend at this time could
produce unpredictable results. The reason code (rc) shown in this message provides
additional information about the reason the job step was not abended. The following
reason codes (rc) are possible:
