A SERVICE OF

logo

BMC Software, Inc., Confidential and Proprietary Information
192 Application Enhancement Solutions Messages Manual
BMC74211I THE CURRENT REGION IS BEING TERMINATED AFTER A type DL/I
CALL ON BEHALF OF exitname.
Explanation: APPLICATION RESTART CONTROL (AR/CTL) is terminating
the current task after the given type of application program DL/I call on behalf of the
named checkpoint pacing user exit routine (exitname).
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
BMC74212E FUNCTION function IS NOT PERMITTED IN THE NATIVE
ENVIRONMENT.
Explanation: APPLICATION RESTART CONTROL (AR/CTL) does not allow
the application program call to issue the given function code in IMS-compatible
mode. The following function codes are valid in IMS-compatible mode:
CHKP
CLSE
GN
GU
ISRT
OPEN
ROLB
ROLD
ROLL
TERM
XRST
System Action: AR/CTL abnormally terminates the task with abend U1771 and
reason code X00074212.
User Response: Correct the application program call to use a valid function code.
BMC74213E BMP RESTART AND APPLICATION RESTART CONTROL CANNOT
COEXIST IN THE SAME REGION.
Explanation: BMP RESTART was detected in the same region in which
APPLICATION RESTART CONTROL (AR/CTL) was executing. BMP RESTART
and AR/CTL cannot co-exist in the same region.
System Action: AR/CTL abnormally terminates the task with abend U1771 and
reason code X00074213.
User Response: Remove BMP RESTART from the region where AR/CTL is
installed.