Filter
Top Products
8 NBDP SYSTEM OVERVIEW
8-11
Function key [F6]: System menu
The System menu is mainly for use by technicians and contains diagnostic tests. To
change settings, choose “Change” from the item “Setup” and operate arrow keys to
choose item and option. Press the [Enter] key to register selection and close the menu.
Setup
Slave Delay
TX/RX MSG Save
Edit Before sending
Time System
Time & Date
Display Mode*
Self Test
Lock Change Default
8 msec (0- 50 msec)
OFF O N
OFF O N
OFF UTC SMT JST
2002/10/16 10:00:00
Normal Reverse
System
* = "Window Color" shown on IB-583.
System menu
Setup Locks, changes settings; restores default system settings.
Slave Delay Sets the length of the slave delay timing from the end of RX to
the start of TX in the ARQ mode. The default setting is suitable in
most cases. This item cannot be adjusted by the user.
ARQ mode
signal
sequence
3 char. RX 3 char. RX
RX end TX start
ACK signal
Slave Delay Timing
TX/RX MSG Save Turn on to automatically save incoming and outgoing messages
to a floppy disk. “Log” appears at the top of the screen when on.
Edit Before sending "OFF" transmits keying operation one by one. "ON" transmits
message only when the [Enter] key is pressed after confirming
text typed.
Time System Chooses time system. SMT is local time and JST is Japan
standard time.
Time & Date Enter date and time manually. If a navigation device is connected,
the time is automatically set when the power is turned on or
whenever the time system is switched. Manual entry takes
priority over automatic entry. This item cannot be adjusted when
using JST or UTC.
Display Mode (IB-581) Selects display mode to normal and reverse alternately.