Filter
Top Products
5 CALLING, RECEIVING
5-13
4. Rotate the [ENTER] knob to choose ABLE and then push the [ENTER] knob. The
display changes as below. (Working frequency is automatically set as specified by other
party.)
DSC FREQ: 4M-INTL
STATION ID: 121234567
COM. TYPE: TELEPHONE
COM. FREQ: CH401
CALL TYPE: ABLE
ACKNOWLEDGEMENT
**
Compose message
**
GO TO ALL VIEW
5.
Press the [CALL] key to send the call. The display changes as below.
Able acknowledge
call in progress!
TIME TO GO: 7S
DSC FREQ : 4208.0
KHZ
TO SHIP :
121234567
ROUTINE
TELEPHONE CH 401
6.
After the call is completely sent (transmission time: 7 sec.), the radiotelephone screen
appears (if the communications mode is telephone). You can begin voice
communications by radiotelephone. For NBDP operation, do the following:
Communicating by NBDP Terminal Unit
After acknowledging an individual call, do the following to communicate by NBDP Terminal
Unit.
1. The control unit’s display shows “OCCUPIED” and the TX and RX frequencies.
2. The message from the other party appears on your NBDP Terminal Unit.
3. After receiving the message from the other party, type your message and transmit it.
4. Press the function key [F10] (BREAK) to disconnect the line.