Filter
Top Products
12 MAINTENANCE & TROUBLESHOOTING
12-6
Routine and Business
priorities only.)
EPFS error No position data from
navigator for one minute.
Press the [CANCEL] key to silence the
alarm. Check the navigator. If it is
malfunctioning, manually enter position.
Incoming Incoming DSC call Message is automatically cleared when
DSC signal has gone.
No position data You attempted to enter
position automatically when
there is no position data.
Check the navigator.
No response: RT Radiotelephone not powered
or has been disconnected.
Check radiotelephone.
Oven cold. Tx not
ready; wait
Oven too cold; cannot
transmit.
Wait until the oven becomes sufficiently
warm.
Printer not ready Automatic printed has been
selected; however, printer is
not powered or has been
disconnected.
Check printer.
Trouble: Oven not
ready
Oven not ready; cannot
transmit.
Wait until the oven is ready.
TRX PLL UNLOCK TRX PLL unlock.
Transmission is stopped.
Check if the reference oscillator is
working and the coaxial cable is tightly
connected.
TUNE error Tuning failed for DSC or
NBDP. Transmission (except
distress) is stopped.
Try to tune again.
Warning: Update
position
Position data is older by the
amount of time preset on the
Alarm menu.
Press the [CANCEL] key to silence
alarm. Reenter position on the Position
menu.
Watchdog error.
Please Power OFF
Internal error (such as CPU
trouble) detected.
Accompanied with alarm,
same type as for distress.
Turn the power off and on to erase the
message. Have a qualified technician
check the set.
WR1 PLL UNLOCK
WR2 PLL UNLOCK
WR1, WR2 PLL unlock.
Transmission is stopped.
Check if the reference oscillator is
working and the coaxial cable is tightly
connected.