Filter
Top Products
11 NBDP TRANSMITTING, RECEIVING
11-9
When the predetermined time comes, the NBDP Terminal Unit automatically sends or
receives the message. The results of timer operation are displayed as either OK or NG
(No Good) on the Timer Operation List.
*1
2
*3
*OP4
*OP5
OK
OK
OK
NG
Timer Operation List
Timer operation list
11.6.2 Stopping timer operation
1. Press the function key [F3].
2. Press the [7] key.
3. Choose the operation (name) which has an asterisk attached to it and then press the
[Enter] key. Remove all asterisks to cancel all timer programs.
11.7 Scanning
The radio equipment scans a group of operator-selected frequencies (channels), and
stops scanning when an signal is received. For registering scan group, see paragraph 9.5.
1. Press the function key [F3] and then the [5] key to show the Scanning Group List on
your screen.
You can confirm the scan channel by pressing the [↑] or [↓] key while pressing the [Shift]
key.
*1
2
3
Scanning Group List
Scanning group list
2. Choose a scan group and press the [Enter] key.
3. The scanning starts and the indication "Scan" appears in reverse video. Further, the
name of the scan group appears in the Station Name field.
2002-09-08 2:01:46 UTC Caps-Eng
1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
Station Name : SAITO-1 Scan HT
Frequency (T/R) : 8344.00 / 8705.00(kHz) Comm Mode : Auto
Comm Status : Connect Send Lock Error
Sending Volume : 100(%) ARQ Error : 0 ARQ Time : 0(sec)
Communication status display
4. To stop scanning, press the function key [F3] and then the [5] key. “Scan” appears in
normal video on the communication status display.