Filter
Top Products
9 NBDP PREPARATIONS
9-6
11. To enter another timer program, press the [Enter] key twice and the repeat steps 3-10.
12. Press the [Esc] key to finish.
9.3.2 Editing/Deleting timer programs
1. Press the function key [F5] and the [2] key.
2. Choose a timer program name from the Timer Operation List.
3. Press the [→] key to choose Change and press the [Enter] key.
4. Do one of the following;
Edit program: Use [↑], [↓] and the [Backspace] key to make corrections.
Delete program: Erase operation name with the [Backspace] key.
5. Press the [Enter] key twice.
6. Press the [Esc] key.
9.4 User Channels
The user channel list provides storage for up to 100 user channels, numbered 0-99. Note
that user channels may be used in channel scanning.
9.4.1 Registering user channels
1. Press the function key [F5] and then the [4] key to show the User Channel Entry
screen.
User Channel Entry
Create
Change
Channel List
Channel Set Up
Channel : _
Tx Freq : 0.00
Rx Freq : 0.00
User channel entry screen
2. If Create is not underlined, press [→], [↑] and the [Enter] key to underline it.
3. Channel is selected. Enter channel number. (100 channels may be registered. When
you attempt to register more, the message “Channel memory is full. Press any key to
escape.” appears. In this case delete unnecessary channels to register new ones.)
4. Press the [↓] key to choose “Tx Freq.” Enter TX frequency.
5. Press the [↓] key to choose “Rx Freq.” Enter RX frequency.
6. Press the [Enter] key. The”OK/Cancel” confirmation window appears.
7. Press the [Enter] key. Channel number entered appears in the Channel List. (If the
channel entered already exists, the message “Channel by that number already exists.
Press any key to escape.” appears. Press any key and then reenter number.)