Filter
Top Products
11 NBDP TRANSMITTING, RECEIVING
11-4
5. Transmit message by one of the following methods:
Sending a file stored on a floppy disk
a) Press the function key [F7] (WRU) to receive the answerback code of the other
station. Verify that the code from the station called is correct.
b) Press the function key [F8] (HR) to transmit your own identity (answerback code).
c) Press the function key [F3] and then the [3] key to display the Send screen. Choose
file to send and press the [Enter] key. Press the [Enter] key again, and “Send”
appears in reverse video while the file is being transmitted.
[B:\TEST1. ]
File name Size Date & Time
LOG File 52 02-10-15 17:25
TEST1. 120 02-10-10 16:30
TEST2. 151 02-10-11 09:25
TEST3. 180 02-10-11 20:16
NBDP 169 02-10-12 06:23
[ End of Directory ]
4 Files exist 1454000 bytes free
To select : ENTER To view : SPACE To quit : ESC
Send File
Send file screen
Sending volume (percentage of message transmitted, counts upward as the message is
being transmitted), ARQ error count and ARQ transmission time appear on the display.
“Lock” appears in reverse video when the mark and space signals in the receive signal are
normal. “Sending Volume” shows what percentage of the message has been sent. “ARQ
Error” shows the number of times error was found during transmission. “ARQ Time” is the
time in seconds the communication line has been established.
Station Name :
Frequency (T/R) : 8765.00 / 8965.00(kHz) Comm Mode :ARQ
Comm Status : Connect Send Lock Error
Sending Volume : 100(%) ARQ Error : 0 ARQ Time : 0(sec)
Caps-Eng
1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
2002-09-08 2:14:28 UTC
HT
Communication status display
Type a message from the keyboard
After exchanging answerback code by the function key [F7] (WRU) and [F8] (HR), type
your message directly from the keyboard.
a) To change direction of traffic, press either function key [F9] (OVER), or [+] and [?]. Then,
the other station becomes the information sending station, your station the information
receiving station.
b) Receive a message from the sending station, if any.
c) After completion of communication, press the function key [F7] (WRU) key to receive the
answerback code of the other station and then press the function key [F8] (HR) to
transmit your own answerback code.
d) Press the function key [F10] (Break) to disconnect the line.