Filter
Top Products
2-1
2 SSB RADIOTELEPHONE
You can enter desired frequency by channel or TX and RX frequencies. The handset may
be ON HOOK or OFF HOOK. To set the SSB radiotelephone to 2182 kHz/J3E
automatically, press the [1/ RT/2182] key more than two seconds.
2.1 Transmitting
After selecting class of emission and frequency, you can transmit by pressing the PTT
switch on the handset. Output power is shown on the display.
2.1.1 Choosing class of emission
1. At the radiotelephone screen, choose class of emission (mode) as follows:
Rotate the [ENTER] knob to choose MODE and then push the [ENTER] knob.
MODE: SSB SIMP HIGH
CH: 800
TX: 2182.0 KHZ
RX: 2182.00 KHZ
VOL
SEN
S
AGC : FAST
IA 0.0A
TLX
AM
SSB
Rotate the [ENTER] knob to choose mode desired and then push the [ENTER] knob. SSB:
Single Sideband, TLX: Telex, AM: AM. (You cannot transmit on the AM mode.)
2. AGC is automatically selected according to mode. AGC FAST: SSB, AGC OFF: TLX,
AGC SLOW: AM. However, you may change it as below.
a) Rotate the [ENTER] knob to choose AGC and then push the [ENTER] knob.
MODE: SSB SIMP HIGH
CH: 200
TX: 2182.0 KHZ
RX: 2182.00 KHZ
VOL
SEN
S
AGC : FAST
IA 0.0A
FAST
FAST
OFF
SLOW
FAST
b) Rotate the [ENTER] knob to choose OFF, SLOW or FAST as appropriate and then push
the [ENTER] knob.