Filter
Top Products
9 NBDP PREPARATIONS
9-4
8. If you selected "Channel" at step 6, enter ITU channel number (see Appendix) or User
channel number.
If you selected "ScanTable" at step 6, press the [→] key to show scan group list registered.
For scan group, refer to paragraph 9.5. Choose a scan group name by using the [↓] or [↑]
key followed by pressing the [Enter] key.
Scanning Group List
INTREPID
VOYAGER
GLOBAL
▼
Scanning group list
9. Press the [Enter] key. The prompt OK/Cancel asks for verification of data.
O K
Cancel
OK/Cancel prompt
10. If the data are correct, press the [Enter] key. (To cancel entry, place the cursor on
Cancel by pressing the [↓] key, and then hit the [Enter] key. Data entered are erased.)
The station name entered at step 3 appears at the Station List window.
11. To register other stations, press the [Enter] key twice and then repeat steps 3 through
10.
12. Press the [↓] key. Check data on the Station List for correctness. Stations displayed in
reverse video on the Station List are displayed on Station Set Up.
13. Press the [ESC] key to quit.
Note 1: If you enter a station which already exists, the indication "Station by that name
already exists. Press any key to escape." appears. Press any key to return to the
Station List. Check the list.
Note 2: If you enter an invalid code, the message “Input Error. (ID Code) Press any key to
escape.” appears. Press any key and reenter ID code.
9.2.2 Editing/Deleting stations
1. Press the function key [F5] and then the [1] key.
2. Press the [↓] key to choose a station name from the Station List.
3. Press the [→] key followed by [↓] key to choose Change and press the [Enter] key.
4. Do one of the following;
Edit station: Use [↑], [↓] and the [Backspace] key to make corrections.
Delete station: Erase station name with the [Backspace] key.
5. Press the [Enter] key twice.
6. Press the [Esc] key.