Filter
Top Products
152
Internet
• To access WAP services you need to define WAP access points in your
communicator. WAP access points are additional to the Internet settings. You
can receive WAP access points directly via a short message from your WAP
service provider, or define them manually. This chapter contains instructions for
manual setup.
• Certain bookmarks can be accessed through a specific access point, for
example, banking services may have to be accessed through the bank’s own
access point. The easiest way to use these kinds of services is to define an
altogether new bookmark which uses the correct WAP and Internet access
point.
To set up WAP connections
Note: Before you can use the WAP services, you need to configure your WAP
settings. Your WAP service provider will provide you with the exact
values for the WAP settings. Follow the instructions carefully. You can
use this information to define and edit the settings manually.
Furthermore, your service provider may be able to send some, or all, of
the required settings to you via a special short message, an Over The Air
(OTA) message. After you have received the settings, you can start using
the WAP application or edit the settings as described below.
To define and edit WAP connections
1 Press the Menu key and select Tools > WAP access. A dialog opens.
2 Press New to create a new connection, and Edit to edit an existing connection.
A dialog opens. See Figure 64.
Linda1.book Page 152 Friday, April 12, 2002 8:31 PM