Filter
Top Products
OnCell G2150I AT Command Set MOXA Proprietary Commands
11-2
Firmware Upgrade: *UPG
Description: This command triggers a X-modem(checksum) downloading session for G2150I
firmware image. .
Notes:
• There will always be risks when performing the firmware upgrade. Ensure to
have fixed physical connection on both the power and the signal lines, and to have
the correct image file.
• System responses with “Clean-up OK All Done!!” message on the terminal if
the upgrade is successful.
• X-modem receive timeout: 10 sec.
Example
AT + UPG
Moxa Firmware Upgrader, v1.0
*UPG: 73851 bytes transferred, in 45s
Upgrading, please keep power intact and wait for a moment…
CR
+WIND: 13
Restoring modem defaults, please wait…
OK
Clean-up OK
All Done!!
OK
+WIND: 13
NOTE
Upgrading the firmware will clear all the settings and reset the OnCell G2150I to its factory
defaults.