Filter
Top Products
OnCell G2150I AT Command Set Call Control Commands
4-7
activated using +CLCK command). Voice call (with semi-colon).
AT%D1 Activates automatic DTR dialing if DTR switches from OFF to ON; Dials the
phone number in the first location of the ADN phonebook (or FDN phonebook, if
it is activated using +CLCK command). Data or Fax call (without semi-colon).
AT%D2 Activates automatic DTR short message transmission if DTR switches from OFF
to ON. Sends the short message in the first location of the SIM.
If the first location is empty:
• AT%D1 and AT%D2 commands will receive an OK response
• The DTR ON event will trigger a CME ERROR: 21 or a CMS ERROR: 321.
Automatic Answer: ATS0
Description: This S0 parameter determines and controls the product automatic answering mode.
Command syntax: ATS0=<value>
Command Possible responses
ATS0=2
Note: Automatic answer after 2 rings
OK
ATS0?
Note: Current value
002
OK
Note: always 3 characters padded with zeros
ATS0=0
Note: No automatic answer
OK
Note: Command valid
All others S-parameters (S6,S7,S8 …) are not implemented.
Defined values: <value>
number of rings before automatic answer (3 characters padded with zeros). Range of values is
0 to 255
Incoming Call Bearer: +CICB
Description: This specific command is used to set the type of incoming calls when no incoming
bearer is given (see +CSNS).
Note: setting the +CICB command affects the current value of +CSNS.
Command syntax: AT+CICB=<mode>
Command Possible responses
AT+CICB=1
Note: If no incoming bearer, force a fax call
OK
Note: Command accepted
AT+CICB=2
Note: If no incoming bearer, force a voice call
OK
Note: Command accepted
AT+CIC B?
Note: Interrogate value
+CICB: 2
OK
Note: Default incoming bearer: voice call
AT+CICB=?
Note: Test command
+CICB: (0-2)
OK
Note: Speech, data or fax default incoming
bearer
Defined values: <mode>
0: Data
1: Fax
2: Speech