Filter
Top Products
OnCell G2150I AT Command Set General Commands
3-3
Request Revision Identification: +CGMR
Description: This command is used to get the revised software version. This function only applies
to default IP addresses.
Command syntax: AT+CGMR
Command Possible responses
AT+CGM R
Note: Get software version
657_09gg.02406B 2015268 100506 17:01
OK
Note: Software release 6.57, generated on the 5
th
of October
2006
Defined values: No parameters
Product Serial Number: +CGSN
Description: This command allows the user application to get the product’s IMEI (International
Mobile Equipment Identity, a 15 digit number).
Command syntax: AT+CGSN
Command Possible responses
AT+CGSN
Note: Get the IMEI
012345678901234
OK
Note: IMEI read from EEPROM
AT+CGSN
Note: Get the IMEI
+CME ERROR: 22
Note: IMEI not found in EERPROM
Defined values: No parameter
Select TE Character Set: +CSCS
Description: This command informs the ME which character set is used by the TE. The ME can
convert each character of entered or displayed strings. This is used to send, read or write short
messages. See also +WPCS for the phonebooks’ character sets.
Command syntax: AT+CSGS =<Character Set>
Command Possible responses
AT+CSCS=“GSM”
Note: GSM default alphabet
OK
Note: Command valid
AT+CSCS=“PCCP437”
Note: PC character set code page 437
OK
Note: Command valid
AT+CSCS=?
Note: Get possible values
+CSCS:
(“GSM”,”PCCP437”,”CUSTOM”,”HEX”)
OK
Note: Possible values
Defined values: <Character Set>
“GSM” GSM default alphabet.
“PCCP437” PC character set code page 437.
“CUSTOM” User defined character set (cf. +WCCS command).
“HEX” Hexadecimal mode. No character set used; the user can read or write
hexadecimal values.