Filter
Top Products
OnCell G2150I AT Command Set General Commands
3-4
Phonebook Character Set: +WPCS
Description: This specific command informs the ME which character set is used by the TE for the
phonebooks. The ME can convert each character of entered or displayed strings. This is used to
read or write phonebook entries (parameters <text>, <address>, and <mail>). You may also refer
to the definition of +CSCS above.
Command syntax: AT+WPCS=<Character Set>
Command Possible responses
AT+WPCS=“TRANSPARENT”
Note: Transparent mode
OK
Note: Command valid
AT+ WPCS =“CUSTOM”
Note: Custom character set
OK
Note: Command valid
AT+WPCS=?
Note: Get possible values
+WPCS:(“TRANSPARENT”,”HEX”,”CUSTOM”)
OK
Note: Possible values
Defined values: <Character Set>
“TRANSPARENT” Transparent mode. The strings are displayed and entered as they
are stored in SIM or in ME.
“CUSTOM” User defined character set (cf. +WCCS command).
“HEX” Hexadecimal mode. No character set used; the user can read or
write hexadecimal values.
Request IMSI: +CIMI
Description: This command is used to read and identify the IMSI (International Mobile
Subscriber Identity) of the SIM card. The PIN may need to be entered before reading the IMSI.
Command syntax: AT+CIMI
Command Possible responses
AT+CIMI
Note: Read the IMSI
208200120320598
OK
Note: IMSI value (15 digits), starting with MCC (3digits) /MNC
(2digits, 3 for PCS 1900)
See appendix 19 Codes and values for MCC / MNC description.
Defined values: No parameters
Card Identification: +CCID
Description: This command orders the product to read the EF-CCID file on the SIM card.
Command syntax: AT+CCID
Command Possible responses
AT+CCID
Note: Get card ID
+CCID:”123456789AB111213141”
OK
Note: EF-CCID is present, hexadecimal format
AT+CCID?
Note: Get current value
+CCID:”123456789AB111213141”
OK
Note: Same result as +CCID