Filter
Top Products
OnCell G2150I AT Command Set V24-V25 Commands
9-8
Restore Factory Settings: &F
Description: This command is used to restore the factory settings from EEPROM. It only
restores the parameters that can be found in paragraph 19 Codes and values (Parameters Storage
paragraph) with AT&F column checked. Those parameters are restored in RAM and in E2P,
overwriting the profile set with AT&W.
Command syntax: AT&F[<n>]
Command Possible responses
AT&F
Note: Ask to restore the factory settings
OK
Note: Done
AT&F0
Note: idem
OK
Note: Done
Defined values: <n>
0: restore factory setting
No other value supported
Display Configuration: &V
Description: This command is used to display the modem configuration.
Command syntax: AT&V<n>
The parameters displayed are the following:
Q:val1, V:val2, S0:val3, S2:val4, S3:val5, S4:val6, S5:val7,
+CR:val8, +CRC:val9, +CMEE:val10, +CBST:val11,
+SPEAKER:val12, +ECHO:val13, &C:val14, &D:val15, %C:val16
+IPR:val17, +ICF:val18, +IFC:val19
Command Possible responses
AT&V
Note: Display active parameters in RAM
Q:0 V:1 S0:000 S2:043 S3:013 S4:010 S5:008
+CR:0 +CRC:0 +CMEE:0 +CBST:0,0,1
+SPEAKER:0 +ECHO:0,0 &C:1 &D:2 %C:0
+IPR:9600 +ICF:3,4 +IFC:2,2
OK
Note: Done
For Echo the first value corresponds to Echo
cancellation 1.
Defined values: <n>
0 Display the modem configuration in RAM (default value if no parameter provided)
1 Display the modem configuration in EEPROM
2 Display the modem factory configuration.