Filter
Top Products
OnCell G2150I AT Command Set General Commands
3-12
AT+CIN D?
Note: read ME indicators current
values
+CIND: <ind>[,<ind>[,…]]
OK
AT+CIND? +CIND: 2,2,1,0,0,0,0
AT+ CIND=?
Note: read ME indicators possible
values
+CIND: (<descr>,(list of
supported<ind>s))[,(<descr>,(list of supprted
<ind>s))[,…]]
OK
AT+CIND? +CIND: 1,2,1,1,0,0,0
Note: battchg:1 – max=5, signal:2 – max=5, service:1 –
we are registered on the network, message:1 – a SMS
has been received, call:0 – no call in progress, roam:0 –
not roaming, smsfull:0 – SIM card is not full of SMS
AT+CIN D=?
Note: read possible value for ME
indicators
+CIND: (“battchg”,(0-5)),(“signal”,(0-5)),
(“service”,(0-1)), (“message”,(0-1)), (“call”,(0-1)),
(“roam”,(0-1)), (“smsfull”,(0-2))
OK
Defined values:
<ind> integer type value, which shall be in range of corresponding <descr>:
0: indicator is OFF or in state which can be identified as “OFF” state
1: indicator is ON or in a state that is more substantial than “OFF” state
2: this value is more substantial than 1, and so on.
Note: If the indicator is a simple ON/OFF style element, it has values 0 and 1.
<descr>:
“battchg”: battery charge level (0 - 5)
“signal”: signal quality (0 - 5)
“service”: service availability (0 - 1)
“message”: message received (0 - 1)
“call”: call in progress (0 - 1)
“roam”: roaming indicator (0 - 1)
“smsfull”: SMS memory storage status in the MT (0 - 2)
0: memory locations are available
1: memory full
2: one SMS has been received in Service Center (SC) but the sms storage where
this SMS tried to be stored is full.
Multiplexing Mode: +CMUX
Description: This command is used to manage (enable or disable) the 3GPP TS 27.010
multiplexing protocol control channel.
This command allows the multiplexing of 4 logical channels on a single UART. Two
UARTs are available on the G2150I, but multiplexing can only apply to one. The client
application may handle, by this means, up to 5 channels (4 logical multiplexed channels
on a UART and 1 physical channel on the other UART).
Notes on speed and autobauding:
• The speed of the response is the same that the one of the received AT+CMUX
command (prior to entering <mode>).
• It is recommended that, whenever the multiplexer control channel is released, the
modem should assume an interface rate for autobauding purposes, irrespective of any
previous higher speed selected.
•If a +CMUX command is issued while in any multiplexer mode, then that +CMUX