Filter
Top Products
OnCell G2150I AT Command Set Data Commands
8-4
+CR: ASYNC For asynchronous transparent
+CR: REL ASYNC For asynchronous non-transparent
Command syntax: AT+CR=<mode>
Command Possible responses
AT+CR=0
Note: Extended reports disabled
OK
Note: Command valid
AT+CR=1
Note: Extended reports enabled
OK
Note: Command valid
AT+CR? +CR: 1
OK
AT+CR=? +CR: (0,1) OK
Defined values: <mode>:
0: disable extended reports
1: enable extended reports
Cellular Result Codes: +CRC
Description: This command allows more detailed ring information for an incoming call (voice
or data). Instead of the string “RING”, an extended string is used to indicate which type of call is
ringing (e.g. +CRING: VOICE). These extended indications are:
+CRING ASYNC for asynchronous transparent
+CRING: REL ASYNC for asynchronous non-transparent
+CRING: VOICE for normal speech.
+CRING: FAX for fax calls
Command syntax: AT+CRC=<mode>
Command Possible responses
AT+CRC=0
Note: Extended reports disabled
OK
Note: Command valid
AT+CRC=1
Note: Extended reports enabled
OK
Note: Command valid
AT+CRC? +CRC: 1
OK
AT+CRC=? +CRC: (0,1)
OK
Defined values: <mode>:
0: disable extended reports
1: enable extended reports
DTE-DCE Local Rate Reporting: +ILRR
Description: This parameter controls whether the extended-format “+ILRR: <rate>“ information
text is transmitted from the DCE to the DTE or not. The <rate> value reported represents the
current (negotiated or renegotiated) DTE-DCE speed rate. If enabled, the intermediate result code
is transmitted in an incoming or outgoing data call, after any data compression report, and before
any final result code (CONNECT)