Filter
Top Products
OnCell G2150I AT Command Set Data Commands
8-5
Command syntax: AT+ILRR = <value>
Command Possible responses
AT+ILRR=0
Note: Local port rate report disabled
OK
Note: Command valid
AT+ILRR=1
Note: Local port rate report enabled
OK
Note: Command valid
AT+ILRR? +ILRR: 1
OK
AT+ILRR=? +ILRR: (0,1) OK
Defined values:
<value>:
0: disable local port rate report
1: enable local port rate report
<rate> can take the following values: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200 (kbps).
Radio Link Protocol Parameters: +CRLP
Description: This command modifies the radio link protocol parameters used for non
transparent data transmission.
Command syntax: AT+CRLP= <iws>, <mws>, <T1>, <N2>, <ver>
Command Possible responses
AT+CRLP=?
Note: Test command
+CRLP: (0-61),(0-61),(40-255),(1,255),(0)
OK
Note: V42bis not supported
AT+CRLP=?
Note: Test command
+CRLP: (0-61),(0-61),(40-255),(1,255),(0,1)
OK
Note: V42bis supported
AT+CRLP=61,61,48,6,0
Note: Set new parameters
OK
Note: Command valid
AT+CRLP?
Note: Current values
+CRLP: 61,61,48,6,0
Note: Command valid
Defined values:
<IWS>: Down window size, (default is 61)
Range 0 to 61
<mws>: Up window size, (default is 61)
Range 0 to 61
<T1>: Acknowledgement timer in units of 10 ms, (default is 48)
Range 40 to 255
<N2>: Retransmission attempts, (default is 6),
Range 1 to 255
<ver>: Version number.
0: V42bis is not supported.
1: V42bis is supported