Filter
Top Products
OnCell G2150I AT Command Set General Commands
3-7
Report Mobile Equipment Errors: +CMEE
Description: This command disables or enables the use of the “+CME ERROR: <xxx>“ or
“+CMS ERROR:<xxx>“ result code instead of simply “ERROR”.
Command syntax: Command syntax: AT+CMEE=<error reporting flag>
Command Possible responses
AT+CMEE=?
+CMEE: (0,1)
OK
AT+CMEE=0
Note: Disable ME error reports, use only “ERROR”
OK
AT+CMEE=1
Note: Enable “+CME ERROR: <xxx>“ or “+CMS
ERROR: <xxx>“
OK
AT+CMEE? +CMEE: 1
OK
Defined values: <error reporting flag>
0: Disable ME error reports, use only « ERROR »
1: Enable «+CME ERROR: <xxx>» or «+CMS ERROR: <xxx>»
Keypad Control: +CKPD
Description: This command emulates the ME keypad by sending each keystroke as a character in
a <keys> string. The supported GSM sequences are listed in the appendix. If emulation fails, a
+CME ERROR: <err> is returned. If emulation succeeds, the result depends on the GSM sequence
activated: Note: In the case where the FDN phonebook is activated, the sequences concerning “call
forwarding” are allowed only if the entire sequence is written in the FDN.
Command syntax: AT+CKPD=<keys>
Command Possible responses
AT+CKPD=“*#21#”
Note: Check every call forwarding status
+CCFC: 0,7
AT+CKPD=“1234”
Note: Sequence not allowed
+CME ERROR 3
Defined values: <keys> Keyboard sequence: string of the following characters (0-9,*,#).
Clock Management: +CCLK
Description: This command is used to set or get the current date and time of the ME real-time
clock.
Command syntax: AT+CCLK=<date and time string>
Command Possible responses
AT+CCLK=“00/06/09, 17:33:00”
Note: set date to June 9
th
, 2000, and time to
5:33 pm
OK
Note: Date/Time stored
AT+CCLK=“00/13/13, 12:00:00”
Note: Incorrect month entered
+CME ERROR 3