Filter
Top Products
OnCell G2150I AT Command Set Result Codes, Failure Causes,, and Other Tables
A-6
231
PDP
deactivation
cause
LLC
link
activation
failed
232
PDP
deactivation
cause
NWK
reactivation
with
same
TI
233
PDP
deactivation
cause
GMM
abort
234
PDP
deactivation
cause
LLC
or
SNDCP
failure
235
PDP
unsuccessful
activation
cause
GMM
error
236
PDP
unsuccessful
activation
cause
NWK
reject
237
PDP
unsuccessful
activation
cause
NO
NSAPI
available
238
PDP
unsuccessful
activation
cause
SM
refuse
All other values in the range 0 to 31 shall be treated as cause 3.
All other values in the range 32 to 47 shall be treated as cause 47.
All other values in the range 48 to 63 shall be treated as cause 63.
All other values in the range 64 to 79 shall be treated as cause 79.
All other values in the range 80 to 95 shall be treated as cause 95.
All other values in the range 96 to 111 shall be treated as cause 111.
All other values in the range 112 to 127 shall be treated as cause 127.
Specific Failure Cause for +CEER
Cause Value Diagnostic
240
FDN
is
active
and
number
is
not
in
FDN
241
Call
operation
no
t
allowed
252
Call
barring
on
outgoing
calls
253
Call
barring
on
incoming
calls
254
Call
impossible
255
Lower
layer
failure
GSM 04.11 Annex E-2: Mobile Originating SM-Transfer
These error causes could appear for SMS commands (+CMGS, +CMSS, +CMGD…)
Cause No. 1
: “Unassigned (unallocated) number”
This cause indicates that the destination requested by the Mobile Station cannot be reached
because, although the number is in a valid format, it is not currently assigned
(allocated).
Cause No. 8
: “Operator determined barring”
This cause indicates that the MS has tried to send a mobile originating short message when the
MS's network operator or service provider has forbidden such transactions.
Cause No. 10
: “Call barred”
This cause indicates that the outgoing call barred service applies to the short message service for
the called destination.