Filter
Top Products
OnCell G2150I AT Command Set Data Commands
8-3
6 4800 bps (modem type: V.32)
7 9600 bps (modem type: V.32)
8 Specific
12 9600 bps (modem type: V.34)
14(*) 1400 bps (modem type: V.34) 65 300 bps (modem type: V.110)
66 1200 bps (modem type: V.110)
68 2400 bps (modem type: V.110)
70 4800 bps (modem type: V.110)
71 9600 bps (modem type: V.110)
75(*): 14400 bps (modem type: V.110)
(*)This speed configures data and fax 14.4 kbps bearers.
<name> No data compression is provided and only asynchronous modem is supported:
<name> = 0.
<ce>: Connection element
0 Transparent only
1(default) Non transparent only
2 Transparent preferred
3 Non transparent preferred
Select Mode: +FCLASS
Description: This command sets the product into a particular operating mode (data or fax).
Command syntax: AT+FCLASS= <n>
Command Possible responses
AT+FCLASS=?
Note: Test command
+FCLASS: (0,1)
OK
Note: Fax class 2 not supported
AT+FCLASS=?
Note: Test command
+FCLASS: (0,1,2)
OK
Note: Fax class 2 supported
AT+FCLASS=0
Note: Data mode requested
OK
Note: Command valid
AT+FCLASS=1
Note: Fax class 1 mode requested
OK
Note: Command valid
AT+FCL ASS?
Note: Current value
+FCLASS: 1
OK
Note: Command valid
Defined values: <n>
0: Data
1: Fax class 1
2: Fax class 2
Service Reporting Control: +CR
Description: This command enables a detailed type of service reporting in the case of incoming
or outgoing data calls. Before sending the CONNECT response to the application, the product will
specify the type of data connection that has been set up.
These report types are: