Filter
Top Products
OnCell G2150I AT Command Set Call Control Commands
4-3
Command Possible responses
AT+CPB S?
Note: Which phonebook is selected?
+CPBS:”SM”,8,10
Note: ADN phonebook is selected, 8 locations are
used and 10 locations are available
ATD>SM6 ;
Note: Call index 6 from ADN phonebook
OK
Note: Call succeeds
When the FDN phonebook has been locked, only numbers beginning with the digits of FDN
phonebook entries can be called. For example, if “014629” is entered in the FDN
phonebook all the phone numbers beginning with these 6 digits can be called. The CLIR
supplementary service subscription can be overridden for this call only.
“I” means “invocation” (restrict CLI presentation).
“i” means “suppression” (allow CLI presentation).
Control of CUG supplementary service information by “G” or “g” is allowed for this
call only. The index and info values set with the +CCUG command are used. An
outgoing call attempt could be refused if the AOC service is active and credit has
expired (NO CARRIER). When trying to set up an outgoing call while there is an active
call, the active call is first put on hold, then the call set up is carried out. As per GSM
02.30, GSM sequences may be controlled using dial commands. These sequences can
contain “*”, “#”, but “;” is forbidden. If the sequence is not supported or fails, +CME
ERROR: <err> is returned. In the case where the FDN phonebook is activated, the
sequence concerning call forwarding are allowed only if there are written in the FDN.
See paragraph 19 Codes and values to have the list of supported sequences.
Command Possible responses
ATD*#21#
Note: Check any call forwarding status
+CCFC: 0,7
Note: No call forwarding
ATD**61*+33146290800**25#
Note: Register call forwarding on no reply, with
no reply timer fixed at 25 s.
OK
Note: done
ATD*2#
Note: Bad sequence
+CME ERROR 3
Defined values:
<nb> destination phone number
<I> (optional parameter) “I” means “invocation” (restrict CLI presentation). “i” means
“suppression” (allow CLI presentation).
<mem> phonebook (one of “SM”,”LD”,”MC”,”ON”,”ME”,”RC”,”MT” or “SN”). A default
value can be selected by +CPBS command.
<index> call number at indicated offset from the phonebook selected by the +CPBS command
<name> call number corresponding to given name from the phonebook selected by the +CPBS
command
Hang-Up Command: H
Description: The ATH (or ATH0) command is used by the application to disconnect the remote
user. In the case of multiple calls, all calls are released (active, on-hold and waiting calls). The
specific G2150I ATH1 command has been appended to disconnect the current outgoing call, only
in dialing or alerting state (i.e. ATH1 can be used only after the ATD command, and before its
terminal response (OK, NO CARRIER, ...). It can be useful in the case of multiple calls.
Command syntax: ATH<n>