Filter
Top Products
OnCell G2150I AT Command Set V24-V25 Commands
9-3
DTE-DCE Character Framing: +ICF
Description: This command is used to determine the local serial port start-stop (asynchronous)
character framing used by the DCE.
Command syntax: AT+ICF= <format>[, <parity>]
Command Possible responses
AT+ICF? +ICF: 3,4
OK
Note: Current values
AT+ICF=? +ICF: (1-6),(0-4) OK
Note: Possible values
AT+ICF=2,0 OK
Note: New values
Defined values:
<format>
0: Auto detect (not supported)
1: 8 Data 2 Stop (supported) <parity> parameter is ignored.
2: 8 Data 1 Parity 1 Stop (supported) if no <parity> provided
3: is used by default as <parity> value. 3: 8 Data 1 Stop (supported) <parity> parameter
is ignored.
4: 7 Data 2 Stop (supported) <parity> parameter is ignored.
5: 7 Data 1 Parity 1 Stop (supported) if no <parity> provided, 3 is used by default as
<parity> value.
6: 7 Data 1 Stop (supported) <parity> parameter is ignored.
<parity>
0: Odd (supported)
1: Even (supported)
2: Mark (supported)
3: Space (supported)
4: None (supported)
Notes:
• Setting a character framing different from 8N1 will disable autobauding if it was activated.
Setting it back to 8N1 will not re-enable auto-baud.
• Setting the framing to 8N1 will let autobauding be enabled, if it was already enabled (implying
framing was already 8N1).
DTE-DCE Local Flow Control: +IFCR
Description: This command is used to control the operation of local flow control between the
DTE and DCE.
Command syntax: AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>
Command Possible responses
AT+IFC? +IFC: 2,2
OK
Note: Current values
AT+IFC=? +IFC: (0,2),(0,2) OK
Note: Possible values