Filter
Top Products
OnCell G2150I AT Command Set V24-V25 Commands
9-10
Data / Commands Multiplexing: +WMUX
Description: This specific command allows managing the data / AT commands multiplexing
Command syntax: AT+WMUX=<mode>
Command Possible responses
AT+WMUX=? +WMUX: (0-1) OK
AT+WMUX? +WMUX: 0
OK
Note: Data / Commands multiplexing disabled.
AT+WMUX=1
Note: Enable Data / Commands
multiplexing.
OK
Defined values:
<mode>
0: Multiplexing disabled. When the product is online (data communication in progress),
no AT command can be used (default).
1: Multiplexing enabled. Data flows and AT commands are multiplexed while in online
mode (data communication in progress).
Note: The Multiplexing mode is available to only one UART. If this mode is available on
UART1 and the AT+WMUX=1 command is sent through UART2, the multiplexing mode will
be available on UART2 and disabled on UART1.