Filter
Top Products
OnCell G2150I AT Command Set General Commands
3-11
to GSM 11.11 or 3GPP TS 51.011). After the READ BINARY or READ RECORD command, the
requested data will be returned.
<error>: integer type
3: Wrong format or parameters of the command
13: SIM no response
Mobile Equipment Control Mode: +CMEC
Description: This command selects the equipment that operates the ME keypad, writes to MEi
display and sets ME indicators. If operation mode is not allowed by the ME, +CME ERROR:
<err> is returned
Command syntax: AT+CMEC=[<keyp>[,<disp>[,<ind>]]]
Response syntax: +CMEC: <keyp>,<disp>,<ind>
Command Possible responses
AT+CMEC=[<keyp>[,<disp>[,<ind>]]] +CME ERROR: <err>
AT+CMEC=[<keyp>[,<disp>[,<ind>]]] OK
AT+CMEC? +CMEC: 2,0,0
OK
AT+CMEC=? +CMEC: (2),(0),(0)
OK
Note: no change allowed
Defined values:
<keyp>:
Defined values:
0: ME can be operated only through its keypad (execute command of +CKPD cannot be
used)
1: ME can be operated only from TE (with command +CKPD)
2: ME can be operated from both ME keypad and TE
<disp>: 0: only ME can write to its display (command +CDIS can only be used to read the
display)
1: only TE can write to ME display (with command +CDIS)
2: ME display can be written by both ME and TE
<ind>: 0: only ME can set the status of its indicators (command +CIND can only be used to
read the indicators)
1: only TE can set the status of ME indicators (with command +CIND)
2: ME indicators can be set by both ME and TE
Indicator Control: +CIND
Description: This command is used to read or set the values of ME indicators. If ME does not
allow setting of indicators or ME is not currently reachable, an error code is returned.
Command syntax:
Command Syntax: AT+CIND=[<ind>[,<ind>[,…]]]
Response syntax: +CIND: <ind>[,<ind>[,…]] or
+CIND: (<descr>,(list of supported <ind>s)) [,(<descr>,(list of supported
<ind>s)) [,…]]
Command Possible responses
AT+CIND=[<ind>[,<ind>[,…]]] +CME ERROR: <err>
Note: ME not reachable