Filter
Top Products
-.
INSTALLATION-PERIPHERALS
SECTION lOO-816-207
MARCH1993
25PAI R
SEE
PROGRAM 77-1,
LED 07,20
I
FOR RELAY OPTIONS
NOTE:
I
I
I
Unlock Door 0
assigned to digital and electronic
telephones in Program 39 with
Code 71.
PIOUS MDF
Kl/Pi 0 (24VDC, 1 .O AMP MAX.)
TO DOOR LOCK
8-23
. TERMINAL ON FRONT EDGE OF PCB
FlGURE7-8
DK16 DOOR LOCKCONTROL OPTlON(PIOU/PIOUS)
programmed to activate continuously when the Night
Transfer 1 button (only) is set to NIGHT mode (for
indirect answering machine control); or to pulsate at
1 -second ON/3-seconds OFF (for a night bell) when
incoming CO lines night ring over external page
(Program 78-13)
(NTI = tenant 1 CO lines; Nl2 =
tenant 2 CO lines) per
Program 15.
3.33 When configured for the Music-on-Hold func-
tion with
Program
77-1, the relay activates any
time a CO line is on hold. In this configuration, the
relay is normally used to control the Music-on-Hold
source.
3.34 DK16 Night Transfer Relay Control.
Con-
figure the PIOU or PIOUS for the Night Transfer
Relay function in accordance with the following
steps (refer to Figures 7-6 and 7-7):
1)
Access
Program 77-1.
Set
LED 05
to OFF to
configure the Night/Hold Relay for the Night
Relay function.
2)
Access
Program 77-1.
Set
LED
06 to provide
continuous or pulsating relay activation as
follows:
l
OFF-Programs the relay for continuous
activation when NTI button (only) is set.
l
ON-Programs the relay for pulsating
activation when the NTI or NT2 button
is set to NIGHT mode and a tenant 1 or
tenant 2 CO line rings.
NOTE:
CO lines must be enabled in Program 78-13
for the NT pulsating relay function.
3)
Access
Programs 87, 88,
and 89 to set the
CO lines that will activate the relay (when the
system is in the NIGHT mode).
4)
Access
Program
39 to program a Night
Transfer button (NT1 or NT2) on all tele-
phones that are to transfer the system into the
NIGHT mode.
7-10