Filter
Top Products
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
PROGRAM 29-1, 29-27
DK16 DSS CONSOLE (DDSS AND HDSS) BUTTON ASSIGNMENTS
CONSOLE 0
m-mmmm-mT;in~-nnom-~-m
s
Code:
SELECT = 1 or 2 for consoles 1 or 2, respectively
IT-
-II
DSS Number 1-2:
No. 01 - No. 20
Assign the appropriate
Each system can have up to two consoles. Enter the
Press the button/LED
SpeedDial, CO line
console to which buttons are being assigned (DSS
that is in the same
access, or DSS station
access code to the button
console 1).
1
position as the console
button being assigned.
chosen. See code table
DSS Button Group 1-3: The LED lights and the
below for the buttons to
Each console has three groups LCD displays the console
enter. See Notes 4 and 5.
of 20 LED buttons. Choose the buttons number.
group to be assigned.
Copy this sheet as required and enter the console number and corresponding Select number.
Code Table
I
Button Type
Code
NOTES:
I
For more information, see the instructions preceding the record sheets.
Initialized data assigns the Base Unit, PEKU, or PDKU console to operate with
the telephone connected to the Base Unit’s first digital port or the PEKU or
PDKU’s firstport, respectively. See Program 28 to reassign a console to another
telephone, if desired.
I
NT2
When assigning CO line access buttons (01 - 08) to the DSS console, the
associated telephone must be assignedaccess to the CO line. See Program 40.
Initialized data assigns the AC (Code 89) to Group No. 3 Button 19 and the NT
button (Code 9 1) to Group No. 3 Button 20 on all consoles. All other buttons are
initialized as DSS and SD (for Station Speed Dial) buttons. Initialized button
assignments are shown after this record sheet.
The NT and AC buttons may be changed to DSS, CO or SD buttons, but they
may not be reassigned to other locations.
Important: OnlyprogramSD, CO, DSS, AC, andNT buttons;programmingother
feature buttons on a console may cause system operation problems.
DSS consoles are not available on DK8.
2-64