Toshiba STRATA DK16 Cell Phone User Manual


 
10.84 Internal PC to External PC Test Call Using
AT Commands (see Figure 7-36)
1) DIU Programming:
l
Program
20: Port 00. LEDs 01,02, and
17 ON; all other LEDs OFF.
l
Program
20: Port 04. LEDs 01, 02, 03,
04,06, and 17 ON; all other LEDs OFF.
l
Program 21:
Digital port 04 assigned
with KSTU port 08.
l
Program 39:
Port 00. Data Call (56),
Data Release (54), and Modem (55)
buttons should be provided.
l
Default settings for PDIU-DI and PDIU-
DS S-Registers.
2) Make sure PC 1 and PC 2 are on-line with a
communications software package and that
the communication parameters of each PC
and communication software package are set
to the same values (data transmission rate,
parity, data bits, stop bits, flow control, etc.).
INSTALLATION-PERIPHERALS
SECTION 100-816-207
MARCH 1993
3) From PC I’s keyboard, type AT D D 14 and
press ENTER (AT commands must be capi-
tal letters).
l
The Data Call LED on DKT 14 will be lit.
l
The CONNECT LED on PDIU-DS 14 will
be lit.
l
The screen on PC 1 displays, CON-
NECT XXXX, where XXXX is the data
transmission speed set by the communi-
cations software.
l
At this time, PC 1 and PDIU-DS 14 are
connected as shown by the thick lines
above (PDIU-DS 14 is in thecommunica-
tion mode); PC 1 is now linked directly to
the RS-232 side of the internal modem;
PC 1 can issue AT commands to the
internal modem, which is now in the
command mode.
l
If DigitaVPDIU-DS port 04 is the only DIU
port connected to the modem
(Program
20, LED 03 ON), the Modem LEDs on all
DKTs will be lit.
MDF
LAPTOP PC 1
STRATA DK8 OR DK16
583-3700
TELEPHONE
TELEPHONE
LINE
674-4700
EXTERNAL
MODEM
(AUTO
PC2
IGURE 7-36
DK8 AND DK16 INTERNAL PC TO EXTERNAL PC TEST CALL USING AT COMMANDS
7-53