Filter
Top Products
Operations for Outgoing Calls
MD Evolution – Dialog 4223 Professional
28
Voice Paging over a Free Extension’s
Loudspeaker
When you call an internal extension that is “FREE”, but does not
answer, you may broadcast a voice page on your called
extension’s loudspeaker.
This allows you to transmit a message on the extension’s loud-
speaker, which will be automatically activated when you request
this service.
The service is available when you attempt to contact an extension
that is equipped with a loudspeaker. Otherwise, the service will be
refused, and the call will continue normally.
To activate the service:
VPAGING Press the dynamic function key shown on the left.
You may broadcast your message to be heard over the called
extension’s loudspeaker.
d or í Replace the handset or press the “C” key to end the call in
handsfree mode.
Notes:
Typically, the time limit for this service is 20 seconds. When
this time limit expires, your extension will be automatically
disconnected, unless the called party picks up their extension,
at which time the call will proceed normally.
The announcement may be unidirectional from your exten-
sion. It may also be bi-directional, in which case the called
extension’s microphone is automatically activated at the
same time as his/her loudspeaker. In the second case, your
called party can answer you without lifting their handset.
This depends on your called party’s extension settings. See
also the “Programming Your Extension” section.
Certain extensions (such as yours) may possibly be equipped
with permanent protection against voice paging. Obviously,
this service will be denied on these extensions (and vice-
versa).
L1 SMITH Peter-405
FREE
DTMF VPAGING CALL_BACK FLASH >