Filter
Top Products
Section 1A. Setting Up Service 3
Setting Up Service
2. Install the battery by following these steps:
Ⅲ Align the battery’s exposed copper contacts with the battery connectors inside the battery
compartment.
Ⅲ Insert the contact’s side of the battery first and then gently push the battery into place.
Ⅲ Replace the back cover.
Turning the Device On for the First Time
1. Press and hold the Power key for a few seconds.
2. When you turn on your device for the first time, the Quick Start Wizard starts up and guides you to
calibrate the touch screen. Follow the onscreen instructions to complete the screen calibration process.
3. The wizard then starts a basic tutorial that illustrates how to use the stylus to perform copy and paste
operations. You can choose to go through the tutorial or tap
Skip to cancel the tutorial.
4. The wizard then allows you to set a device password. You can cancel this first and do it at another time.
For instructions on how to set a device password, see “Protecting Your Device” on page 114.
5. After the Quick Start Wizard finishes, your device goes through a customization process. Wait for the
customization to complete.
6. Your device then restarts itself.
Ⅲ If your device’s phone is already activated, it will search for Sprint service and then enter standby mode.
Ⅲ If your device’s phone is not yet activated, see “Activating Your Device” on page 4 for more information.
Note
Your device’s battery should have enough charge for your device to turn on and find a signal, set up your
voicemail, and make a call. You should fully charge your battery as soon as possible. See ““Charging the Battery”
on page 16 for details.