Filter
Top Products
118 Section 2I. Managing Your Device
Using the Strap Holder
The strap holder at the bottom panel of your device allows you to attach a wrist strap, neck lanyard, or string
accessory.
To attach a strap, lanyard or string accessory to the strap holder:
1. Remove the back cover.
2. Insert the loop of the strap, lanyard, or string accessory through the strap holder hole on the back cover.
3. Use the stylus to pry off the rubber cap on the small hook at the bottom of the back side of the device,
and then attach the loop over the small hook.
4. Slightly pull the strap, lanyard, or string accessory to fix it securely in place, and then replace the rubber
cap.
5. Replace the back cover.
Tip
To pass a loop through the strap holder easier, push the loop into the strap holder hole using a pointed
object such as a needle or toothpick.