Filter
Top Products
3332
Adjusting the brightness or white
balance
You can adjust the brightness or white
balance of the image you are sending.
1 Press [Options], select Settings
and press O, then select Bright-
ness or White Balance and press
O.
2 Adjust the brightness using u / d,
or adjust the white balance by
selecting Auto, Sunny, Cloudy,
Electric Light, Fluorescent 1, or
Fluorescent 2 and pressing O.
Reducing flicker
Occasionally the image may flicker due
to less than optimal local frequency.
You can use the “Flicker-free” function
to reduce this problem. Flicker is likely
to occur when you move between
areas using different frequencies (50
hertz or 60 hertz).
Note: It is possible that the flicker may not
be removed completely even after
you changed this setting. However,
this is not considered to be a
problem with the phone.
1 Press [Options], select Settings
and press O, then select Flicker-
free and press O.
2 Select 50 Hz or 60 Hz and press
O.
Sending a video stored in the Media
Album
You can retrieve a video stored in the
phone and send it to the other party
during a video call. See p. 81 for
details about the Media Album.
1 Press [Options], select Send Video
Clip and press O.
2 Select a video in the Media Album
and press O.
3 Press [YES].
• During the sending of video
image data you cannot talk on
the phone.
Using Anti-Nuisance Function
You can reject an incoming call by
sending the caller’s voice back with a
blank image.
•Press [Options], select Echo Party
Voice and press O. Press [Cancel]
to release the function and return
to talking.
Activating Hands-free
This function raises the sensitivity of
the microphone and increases the
volume of the speaker temporarily so
that you can talk hands-free with the
phone on flat stable surface. The
setting changed here returns to the
previous one when you finish the video
call. (See also p. 133)
•Press [Options], select Hands-free
ON and press O. To deactivate
hands-free, press [Options] again
and select Hands-free OFF.
Putting the call on hold (Hold)
This function turns OFF the micro-
phone and sends a recorded video
message to the caller until you are
ready to resume talking.
•Press [Hold]. Images of both the
other party and yourself disappear.
The recorded video message is sent
to the caller.
Note: After putting the call on hold, press
[Un-hold] to resume talking.
Video Call Video Call