Sanyo S750i Cell Phone User Manual


 
149148
4 Repeat the procedure until sounds
have been selected for all the
entries.
5 Press [Set] to finish the setting.
6 Enter the Snooze Time and press
[Set].
7 Press [Save] to save the setting.
Turning off the Snooze mode setting
Select OFF at the Snooze mode
setting display and press O.
When the set time arrives
The alarm sounds for up to 60
seconds. Press [Stop] or any other key
to silence the alarm.
The alarm sound stops and the phone
goes into Snooze Mode (if it is set).
•Press and hold O to cancel the
Snooze mode.
If you receive an incoming call during
Snooze Mode, the mode is
automatically cancelled.
Resetting Alarm Clock entries
1 In Standby mode, press [Menu],
highlight
and press O.
2 Select Alarm Clock and press O.
A list of eight Alarm Clock entries
appears.
3 Select the entry you want to reset
to empty and press [Reset].
Calculator
You can perform the addition,
subtraction, multiplication, and division
on numbers consisting of up to 10
digits.
Note:
If an incoming call or an alarm is
detected while you are using the
calculator, the calculation is automatically
terminated without storing the result.
1 In Standby mode, press [Menu],
highlight
and press O.
Voice Recorder
You can record voice sounds up to the
total storage capacity of the phone’s
Media Album and SD Card. If a SD
Card is inserted, the voice sound is
automatically recorded onto that card.
Recording your voice
1 In Standby mode, press [Menu],
highlight
and press O.
2 Select Voice Recorder, press O.
3 Select Record and press O. The
phone is now in Voice Recorder
mode.
4 Press [Record] to start recording.
5 Press [Stop] to stop the recording.
sserPnoitpircseD
0 ot 9
.9ot0slaremunehtsretnE
;
.tnioplamicedasretnE
O
.noitaluclacasmrofreP
]CA/C[
sraelC/srebmunderetneehtsraelC
.atadrotaluclaclla
u
)noitiddA(+
d
)noitcartbuS(-
l
× )noitacilpitluM(
r
)noisiviD(÷
2 Select Calculator and press O.
The initial display of the calculator
appears.
3 Perform your calculation.
4 Press y to return to the Standby
display.
Notes: The calculator can display up to
10 digits.
If the result of a calculation is
more than “9,999,999,999” or less
than “-9,999,999,999”, “E” is
shown at the right end of the
display. Press [C/AC] to clear.
If the result of a calculation is
negative “-” appears to the left of
the number.
Extras Extras