Filter
Top Products
C-2 Specifications
GENERAL (continued)
Electrical Handset 1.0 watt
Specifications: Battery Charger (BC) 15 watts
(Power) Radio Module (RM) 4.0 watts
Carrier (CA) w/6 RMs 24.0 watts
Power Supply (BC) 15 watts (10V 1.5 A)
Power Supply (RM) 6.0 watts (10V 600mA)
Power Supply (CA) 30.0 watts (9V)
Battery Pack Life: Nickel Metal Hydride 3 hours talk time/22 hours standby time
RF SYSTEM
PARAMETERS
Frequency Band: 902 − 928 MHz
Channel Spacing: 150 KHz
Total Channel
Capability: 50 (Channels Dynamically allocated out of 173)
Duplex Method: Time Division Duplex (TDD) (Transmit and Receive on same frequency)
Transmitter Dynamic Power Adjustment: 1mW ERP Minimum to 160mW ERP
Output Power: Maximum
Receiver
Sensitivity: -103 dBm at Antenna Port
OTHER
Electrical
■
105 −130VAC, 50 −60 Hz, 3-prong outlet separate ground, separately
Requirements: fused at 15 amps.
■
Outlet must not be controlled by an on/off switch
■
Grounding to comply with Underwriters Laboratories (UL) 1459
Requirements Installation of a telephone or other standard (tip/ring) device in another
For Out-Of-Building building requires the following In-Range Out-of-Building (IROB)
Extensions: protectors to protect the switch/control unit and telephone device from
electrical surges:
■
MDW 9030P Pocketphone: two Lucent Technologies 503A1 protec-
tors (ETR); two Lucent Technologies 343B protectors (ATL)
Wiring:
■
MDW 9030P Pocketphone: Lucent Technologies SYSTIMAX
®
or at
least 2-pair (4-wire) star (“home run” not “loop”) ETR
■
Lucent Technologies SYSTIMAX or at least 4-pair (8-wire) star (“home
run” not “loop”) ATL
■
Bridging Adapter: Lucent Technologies 267F2 (ETR)
■
Bridging Adapter: Lucent Technologies 267C (ATL)
■
Range: 1,000 feet (305 meters) for the Radio Module (26 AWG)