Filter
Top Products
2-30
Installing the MDW 9030P Pocketphone
Handset
This section explains how to install the handset battery pack, change the communications
system setting, and fill out the handset label.
Inserting and Removing theInserting and Removing the
Inserting and Removing theInserting and Removing the
Inserting and Removing the
Handset’s Battery PackHandset’s Battery Pack
Handset’s Battery PackHandset’s Battery Pack
Handset’s Battery Pack
1
2
To insert the battery pack into the handset,
insert the two small rectangular tabs located
along the bottom back edge of the handset into the
two rectangular holes along the bottom front edge of
the battery pack.
Press the battery pack downward until it clicks
into place.
The battery pack must be charged prior to using the
handset. See “Battery Charger” later in this chapter
for instructions.
3
To remove the battery pack, slide the spring
latch upward (away from the battery pack).
While holding the latch up, grasp both sides of the
battery pack, then gently pull the battery pack upward
and out.
Rectangular tabs
Spring latch