Filter
Top Products
3-12 Using the MDW 9030P Pocketphone
Test ModesTest Modes
Test ModesTest Modes
Test Modes
You can use Local Test Mode and Wireless Test Mode to verify that your handset is
working properly and that the MDW 9030P system is performing optimally.
Using Local Test ModeUsing Local Test Mode
Using Local Test ModeUsing Local Test Mode
Using Local Test Mode
You can use Local Test Mode to activate the audio warning signal, the vibrator, and all
visual indicators on the handset display, enabling you to test the following:
■
Does the audio warning signal work?
■
Does the vibrator vibrate?
■
Is the display operational?
■
Are the visuals bright and clear?
Note:Note:
Note:Note:
Note:
While in Local Test Mode, the MDW 9030P cannot make or receive calls.
1. Make sure the handset is turned off.
2. Press and hold the Select button (") for three seconds.
3. While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating you
are in Local Mode. (While in Local Mode, the MDW 9030P can still receive notification
of incoming calls.)
4. Press # to enter Local Test Mode.
The handset emits two beeps, the vibrator vibrates, and all indicators on the display
appear (including the rectangles and truncated triangles), as shown below.
Local Test Mode
If the beeps do not sound, the vibrator does not vibrate, or the indicators do not
appear, repeat Steps 1–4. If you still have problems, call for customer support as
described on the inside front cover of this book.
3. Press O once to exit both Local Test Mode and Local Mode.
You must exit Local Test Mode to reinstate proper call handling.
MSG
ON
RANGE MUTE