Filter
Top Products
Using the MDW 9030P Pocketphone 3-9
Enabling or Disabling the VibratorEnabling or Disabling the Vibrator
Enabling or Disabling the VibratorEnabling or Disabling the Vibrator
Enabling or Disabling the Vibrator
The vibrator vibrates to alert you to an incoming call in situations where you do not want to
disturb others with an audible ring. You can enable or disable the vibrator using the follow-
ing procedure:
1. Make sure the handset is turned off.
2. Press and hold the Select button (") for three seconds.
3. While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating that
you are now in Local Mode. (While in Local Mode, the MDW 9030P can still receive
notification of incoming calls.)
If the vibrator is enabled, the VIBR icon appears in the display. For example:
If the vibrator is disabled, no icon appears.
4. Press "V" (8) on the dialpad to enable or disable the vibrator.
5. Press O to exit Local Mode.
Note:Note:
Note:Note:
Note:
Both the alerter and the vibrator can be disabled at the same time. In this case the only
notification you have of an incoming call is that a line status indicator (a truncated
triangle or a rectangle, depending on your communications system) flashes in the
display.
Enabling or Disabling Line PreselectionEnabling or Disabling Line Preselection
Enabling or Disabling Line PreselectionEnabling or Disabling Line Preselection
Enabling or Disabling Line Preselection
Line Preselection lets you choose the line or button you want to use before turning the
handset on. For example, suppose your phone is ringing but you want to pick up a call
that is holding on another line instead of the ringing call. In normal operation, the communi-
cations system automatically connects you to the ringing line as soon as you turn on the
handset. With Line Preselection enabled, you can select the line you want to connect to
before turning on the handset.
Note:Note:
Note:Note:
Note:
Under certain conditions, the communications system tries to turn on a speaker; for
example, if you use Line Preselection to select a button programmed for speed-dialing.
Since the MDW 9030P Pocketphone has no speaker, the system causes the ON icon in
the handset display to flutter. You must press O to complete the connection.
Note:Note:
Note:Note:
Note:
When Line Preselection is enabled, you do not have to use it; however you cannot use it
unless it is enabled.
ON