Filter
Top Products
Installing the MDW 9030P Pocketphone
2-11
Wireless Test ModeWireless Test Mode
Wireless Test ModeWireless Test Mode
Wireless Test Mode
You can determine sound clarity, signal strength, and voice quality using Wireless Test Mode.
You should use Wireless Test Mode to help you locate the best place to install the radio
module(s) to optimize the performance of your MDW 9030P Pocketphone. Repeat the tests
several times, with the radio module positioned in a different location each time.
By performing the tests as you walk around the area in which the handset will be used, you can
determine the handset’s range and the voice quality throughout the area of coverage. To perform
the tests, all you need is an electrical outlet for the radio module and a charged battery
pack in the handset. You can perform the tests multiple times and in any order; and you
can exit at any time by pressing O.
NOTE:NOTE:
NOTE:NOTE:
NOTE:
Ignore anything that displays if you press 4 or 5 while in Wireless Test Mode. These
displays are for Lucent Technologies technicians’ use only.
1. Make sure the handset is turned off.
2. Press and hold the Select button (") for three seconds.
3. While still holding " , press O.
The handset beeps twice, and the display shows the handset settings, indicating you
are in Local Mode. (While in Local Mode, the MDW 9030P can still receive notification
of incoming calls.)
4. Press "W" (9) to enter Wireless Test Mode.
WIRELESS TEST appears on the top line of the handset display.
The handset beeps twice and vibrates, then you hear a simulated dial tone. This dial
tone continues until you exit Wireless Test Mode. While in this mode, the MDW 9030P
cannot make or receive calls.
5. To determine sound clarity, listen to the simulated dial tone as you walk around.
A clear, steady tone indicates good sound clarity.
6. To determine signal strength, press 1.
The display shows the signal strength (SIG) for both the handset (HS) and the base (B)
(the radio module) at the moment that 1 was pressed, using a number from 1 to 10, as
shown in the following display.
ON
ON