Filter
Top Products
Installing the MDW 9030P Pocketphone
2-13
Go to one of the following sections:
■
If installing one MDW 9030P Pocketphone, go to “Installing a Single Radio
Module.”
■
Otherwise, go to “Setting the Power Level.”
1
4
Installing a Single Radio ModuleInstalling a Single Radio Module
Installing a Single Radio ModuleInstalling a Single Radio Module
Installing a Single Radio Module
■
Install high on wall, leaving 6–12 inches (15.2–30.5 cm) between antenna and ceiling
■
See “Key Components” earlier in this chapter for additional picture detail
Perform the tests described in "Wireless Test Mode" earlier in this chapter to determine
the optimal placement of the radio module. To perform the tests, all you need is an
electrical outlet for the radio module and a charged battery pack in the handset.
Check to make sure the radio module’s power cord is unplugged from the wall outlet
before continuing.
Screw
Holes
Place the wall-mounting plate against the wall.
Choose a location backed by a wooden stud (if
unavailable, use toggle bolts instead of the supplied
wood screws). Lightly tap a nail into the wall to start
holes. Then screw the plate flush to the wall. Place
the radio module over the plate, then slide it down-
ward to lock it into place. (Note: Do not remove the
plastic cap covering the radio module’s card
edge.)
4
2
Detach the rubber feet from the shipping card.
Apply them to marked areas on the underside
of the radio module.
3