Filter
Top Products
2-6
Installing the MDW 9030P Pocketphone
Radio Modules and Carriers
This section explains how to install radio modules and carriers. You should proceed through
this section in the following order:
1. “Key Components”
2. “Positioning a Single Radio Module or Carrier(s)”
3. "Wireless Test Mode"
4. Choose one of the following paths, depending upon which components you are install-
ing:
■
If you are installing a single radio module, go to “Installing a Single Radio Module.”
■
If you are installing a single carrier (from two to six radio modules), go to “Setting
the Power Level.” Then go to either:
– “Installing a Single Carrier on a Shelf or Desk” or
– “Installing a Single Carrier on a Wall”
■
If you are installing multiple (up to three) carriers (from 7 to 18 radio modules),
go to all of the following, in order:
a. “Setting the Power Level,” then
b. “Setting the Control/Expansion DIP Switch,” then
c. “Installing Multiple Carriers.”
5. “Installation Self-Test”
NOTE:NOTE:
NOTE:NOTE:
NOTE:
The illustrations in this chapter depict PARTNER system hardware; your hardware may
differ from these illustrations.