Filter
Top Products
2-12
Installing the MDW 9030P Pocketphone
The higher the number, the stronger the signal, as shown in the following table. You
can press 1 again to show a subsequent signal-strength reading. Each time you
press 1, you get a new reading.
7. To determine voice quality, press 2.
The display shows the voice quality (QUAL) for both the handset (HS) and the base (B)
(the radio module) using a number from 1 to 10, as shown in the following display.
The higher the number, the better the voice quality, as shown in the table below. A low
number may indicate potential interfering devices (such as another radio transmitter) in
the area. You can press 2 again to show a subsequent voice-quality reading. Each
time you press 2, you get a new reading.
8. To exit Wireless Test Mode and Local Mode, press O.
Display NumberDisplay Number
Display NumberDisplay Number
Display Number
Signal Strength IsSignal Strength Is
Signal Strength IsSignal Strength Is
Signal Strength Is
10 Strong
9 Strong
8 Strong
7 Very good
6 Very good
5 Good
4 Good to Fair
3 Fair
2 Near end of range
1 Near end of range/loss of link
ON
Display NumberDisplay Number
Display NumberDisplay Number
Display Number
Voice Quality IsVoice Quality Is
Voice Quality IsVoice Quality Is
Voice Quality Is
10 Very good
9 Very good/almost error free
8 Errors, but not noticeable in
normal speech
7 Errors, but not noticeable in
normal speech
6 Noticeable noise
5 Noticeable noise
4 Noisy but intelligible speech
3 Noisy but intelligible speech
2 Garbled speech
1 Unintelligible speech