Filter
Top Products
Installing the MDW 9030P Pocketphone
2-29
Installation Self-TestInstallation Self-Test
Installation Self-TestInstallation Self-Test
Installation Self-Test
Upon installation, the POWER and PASS LEDs on each radio module will light. The radio
modules then initiate a 2-minute self-test and synchronization. If a radio module’s PASS LED
does not light, repower the module or its carrier. Refer to Chapter 5, “Troubleshooting,” if
the PASS LED still does not light.
NOTE:NOTE:
NOTE:NOTE:
NOTE:
The RADIO LED also
may
light upon installation; however, since the RADIO LED has no
significance during the self-test, ignore its operation.
The RADIO LED indicates a connection between the handset and the radio module; it
lights when the handset is being used as long as the battery pack in the handset is
charged.
Go to “Handset.”