Filter
Top Products
Using the MDW 9030P Pocketphone 3-13
Using Wireless Test ModeUsing Wireless Test Mode
Using Wireless Test ModeUsing Wireless Test Mode
Using Wireless Test Mode
You can determine sound clarity, signal strength, and voice quality using Wireless Test Mode.
You can also use Wireless Test Mode to identify which radio module matches your handset.
NOTE:NOTE:
NOTE:NOTE:
NOTE:
Ignore anything that displays if you press 4 or 5 while in Wireless Test Mode. These
displays are for Lucent Technologies technicians’ use only.
To identify the matching radio module for your handset, use the following procedure:
1. Make sure the handset is turned off.
2. Press and hold the Select button (") for three seconds.
3. While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating you
are in Local Mode. (While in Local Mode, the MDW 9030P can still receive notification
of incoming calls.)
4. Press "W" (9) to enter Wireless Test Mode.
WIRELESS TEST appears on the top line of the handset display. The handset beeps
twice and vibrates, then you hear a simulated dial tone. This dial tone continues until
you exit Wireless Test Mode. While in this mode, the MDW 9030P cannot make or
receive calls.
5. To identify the matching radio module for this handset, press 3.
The display indicates in which slot in the individual carrier (SLOT:n) the matching radio
module is located, using a number (n) from 1 to 6 . A stand-alone radio module is shown
as 0. For example:
6. To exit Wireless Test Mode and Local Mode, press O.
ON